[Elecraft] P3SVGA

Eric Swartz WA6HHQ - Elecraft eric at elecraft.com
Tue Jun 24 02:26:30 EDT 2014


Also make sure you are powering the P3 from an adequate power supply (at least 1 A).  The SVGA option adds enough current that the 12 V output on unmodified older K3s may not be able to supply enough current for proper operation of the P3 and SVGA together.

73,

Eric
elecraft.com
_..._



> On Jun 23, 2014, at 9:04 AM, Paul Saffren N6HZ <pauls at elecraft.com> wrote:
> 
> Hi Phil, 
> 
> It sounds like the SVGA board is not powering up, or there is something
> wrong with it.  Be sure to check the 40 pin connector between the P3 I/O
> board (serial board) and the SVGA board, and make sure it is aligned
> properly and that all pins are inserted correctly.  Then look at the 40 pin
> ribbon cable and make sure it is connected correctly to the SVGA board.  If
> it all looks correct and you're still not able to get it to work, please
> call Elecraft customer support and we'll get you straightened out. 
> 
> 73, 
> 
> Paul
> 
> 
> 
> 
> 
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/P3SVGA-tp7590405p7590429.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to elist_copy at elecraft.com


More information about the Elecraft mailing list