[Elecraft] Extra TMP cable

[Eric Ross]

I assume you also have the KAT3.  The sub-rx can either be hooked up to
the KAT3 or the AUX RF(bnc) connector, but not both.  When done, there
is a TMP cable that is connected to the KAT3 or AUX RF and one of the
two is not connected to the sub-rx.  You might have missed the step
where you attached that "extra" cable to its chassis connector.  See
Fig. 4 on page 43 in the owners manual.  Unless you plan to have a
receive-only antenna, the dotted line is normally not attached to your
sub-rx.

Eric
WB7SDE

On Mon, Jun 16, 2014, at 11:11 AM, N1IX wrote:
> I just completed assembling a K3 with the sub-receiver option. 
> 
> I have an extra 12" TMP cable and I can't figure out where it goes. 
> 
> The K3 and sub-rx seem to work correctly.
> 
>  
> 
> Dave N1IX
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to epr at evross.com


-- 
  Eric Ross