[Elecraft] Interfacing an old MM transverter

[Don Wilhelm]

When you use the high power setting on the K3, the most obvious solution 
is to change the transverter to a single RX/TX IF connection.
If that is not possible, connect the RX IF line from the transverter to 
the RX ANT input and select the RX antenna for that transverter band.

73,
Don W3FPR

On 6/15/2014 10:28 AM, g3yjr wrote:
> I have connected the receive line from the transverter to the Transverter In
> BNC connector on the back of the rig. When I set that transverter to a low
> power setting the receive works fine, but there is insufficient power to
> drive the separate transmit line to the transverter.
>
> When I choose H2.5W, I can drive the transmit via the Ant1 socket, but the
> Transverter In socket seems disabled, so recieve no longer works.
>
> How do I configure the K3 so that I get 2.5W drive out and a separate
> receive IF line which works?
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/Interfacing-an-old-MM-transverter-tp7590240.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w3fpr at embarqmail.com
>