[Elecraft] Using a P3 for setting TX EQ

[Bill Frantz]

Following the advice in the manual, I was using my K3 to monitor 
the audio while I set the TX EQ in my new KX3. I had the KX3 at 
5 watts into a dummy load and was receiving a strong signal 
through the outside 20M wire beam. I discovered I could use the 
P3 display of the signal to make sure I was getting power in the 
speech frequencies most responsible for intelligibility. It was 
quite useful when combined with listening to the audio. The 
result is also getting good on-air audio reports.

73 Bill AE6JV

-----------------------------------------------------------------------
Bill Frantz        | Concurrency is hard. 12 out  | Periwinkle
(408)356-8506      | 10 programmers get it wrong. | 16345 
Englewood Ave
www.pwpconsult.com |                - Jeff Frantz | Los Gatos, 
CA 95032