[Elecraft] KXPA-100 to ICOM PW-1 amplifier

[Charlie T, K3ICH]

You better make sure you have a reliable ALC connection in there somewhere 
because you'll smoke the PW-1 if you hit it with a hundred watts.  They 
normally take about 35 -45 watts drive for full output.

Why not try driving the PW-1 directly with the KX3?  I did and it works 
fine.  I don't get a KW out, but it's quite respectable power out with 12 
watts drive.

73, Charlie k3ICH


----- Original Message ----- 
From: "George Rebong" <ke6te.9 at gmail.com>
To: <elecraft at mailman.qth.net>
Sent: Tuesday, July 29, 2014 3:25 PM
Subject: [Elecraft] KXPA-100 to ICOM PW-1 amplifier


>I used the RCA from the KX-3 to KXPA-100 adapter cable to connect the PW-1. 
>I can not change transceiver selection on my PW-1 and the RX signal goes 
>deaf/attenuated. Is there a setting that I can change to make my KXPA-100 
>key my PW-1?
>
> Sent from my iPad 3G
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to pincon at erols.com