[Elecraft] IF OUT question

[Don Wilhelm]

Jorge,

If you are talking about the K3 IF output, there is nothing to activate.
Connect a known working receiver tuned to the K3 IF frequency of 8.215 
MHz and you should be able to hear the same signals as the K3 is hearing 
- you may have to tune a couple kHz in either direction to find it, but 
the signal should be present.

If you have a signal generator connected to the K3 input, the signal may 
be easier to find because it should be the only signal present.

If you have an older K3 (prior to September 2009), you will likely want 
to add the IF Output Buffer Gain Modification which increases the signal 
level at the IF output by more than 10 dB.  See 
http://www.elecraft.com/K3/mods/IF_Output_Buffer_Gain_Mod_Rev_A.pdf

73,
Don W3FPR

On 7/26/2014 5:52 PM, Jorge Diez - CX6VM wrote:
> Hello
>
>   
>
> Is there any CONFIG to activate IF OUT?
>
>   
>
> I connected a SDR-IQ to the IF OUT but nothing happens, maybe I need to
> activate some functions?
>
>   
>
> Thanks,
>
> Jorge
>
> CX6VM/CW5W
>
>
>
> ---
> Este mensaje no contiene virus ni malware porque la protección de avast! Antivirus está activa.
> http://www.avast.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w3fpr at embarqmail.com