[Elecraft] Front Panel Changes...

[Cady, Fred]

Good morning.

Tap REC
Tap M1
Tap REC again and your CW keys should return.
Cheers,
Fred KE7X

"The Elecraft K3: Design, Configuration and Operation 2nd ed"
"The Elecraft KX3 - Going for the summit"
"The Elecraft KPA500 and KAT500 - the K-Line Dream Station"
Printed, coil bound copies of these are all available at www.elecraft.com
KPA500 and KAT500 Quick Set Up Guide
http://www.ke7x.com/home/k-line-introduction-and-set-up-guide

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of David Cole
Sent: Saturday, July 19, 2014 6:21 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Front Panel Changes...

Hi,
I have recently been programming Macros...  I noticed that now when in CW mode, if I press the M1 front panel key, I get the EQ for RX.  

I assume there is some way to reassign the FP keys on a K3...  Where can I find out abut this.  I would like the M1 key to revert back to CW memories...

--
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
for MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to fcady at ece.montana.edu