[Elecraft] K3 Front Panel Problem

[Dick Dievendorff]

Another thing to try is load the FPF firmware again. The FPF must match the
MCU, that is, when a set of firmware files is released, don't just load one
file from the set.

Dick, K6KR


-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ellam,
Timothy St. J.
Sent: Tuesday, July 01, 2014 9:59 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Front Panel Problem

Hi



I have an issue with my K3. I keep the antennas physically disconnected here
and the radio had not been turned on for a week or so. Turned it on last
night and it initially worked fine. Made a few Qs on 6m.



I then noticed that I could not switch the VFOs back and forth using the A/B
button. Most of the buttons on the right hand side of the radio are "dead".
I cannot change band, but can change mode. Some buttons appear to be
"remapped". ie: the RX button turns the NB function on and off. The ANT
button does the same thing for the NR function.



The archives suggest this can be fixed by using the restore feature (Holding
Low Cut/Nom knob and cycling the power). I tried that 9saving the config
first), but no luck. The Norm button also does not seem to be functioning
correctly (pushing the knob has no effect, but I can change the cut).



Any ideas? Is there another to try a full restore?



73



Tim VE6SH





________________________________

This e-mail may contain information that is privileged, confidential and/or
exempt from disclosure. No waiver whatsoever is intended by sending this
e-mail which is intended only for the named recipient(s). Unauthorized use,
dissemination or copying is prohibited. If you receive this email in error,
please notify the sender and destroy all copies of this e-mail. Our privacy
policy is available at  www.mccarthy.ca<http://www.mccarthy.ca>.

Click here to
unsubscribe<mailto:listmanager at mccarthy.ca?subject=I%20wish%20to%20unsubscri
be%20from%20commercial%20electronic%20messages%20from%20McCarthy%20Tetrault>
from commercial electronic messages. Please note that you will continue to
receive non-commercial electronic messages, such as account statements,
invoices, client communications, and other similar factual electronic
communications.

Suite 5300, TD Bank Tower, Box 48, 66 Wellington Street West, Toronto, ON
M5K 1E6


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to dick at elecraft.com