[Elecraft] Setting up the frequency offset for the K3 standard filter

[Don Wilhelm]

Carl,

There should be another number on it proceeded by a + or -.  The 2.7 kHz 
is the width, not the offset.
I don't know where they are marking the offset on the filter at the 
present time, but those at Elecraft support should be able to tell you.

That other number should be in the range of -1.28 to +.25.
If it really is marked with an offset of 2.7 kHz, it is a marking 
mistake and you should contact Elecraft to arrange a swap with one that 
is properly marked.

73,
Don W3FPR

On 1/31/2014 5:55 PM, Carl Yaffey wrote:
> The standard 2.7khz filter has the frequency offset marked as 2.7khz. When I try to enter that value during configuration (CONFIG, FL1 FRQ) I see values that range from -1.28 to +.25
> What should I be setting it to?
>
>