[Elecraft] K2 Line Out Mods

[Dennis Moore]

The ground is not needed on the audio output line. If there was to be 
one it would be connected to chassis ground, and that circuit already 
has a chassis ground connection.

An Elecraft-wired mic won't use pin 5, so it's safe to leave the audio 
out connected to pin 5 of the header.

73, Dennis NJ6G

On 1/29/2014 11:21 AM, Kevin Crossett wrote:
> Is the ground from the audio out board still used? If so, where does it
> connect?
>
> Also, while I don't use a mic (CW only at this point), if I attach the
> audio out to pin 5, can I still plug in an Elecraft-wired mic without
> unplugging the audio out connector from the header?
>
> Thanks for any insight...