[Elecraft] K3: Problem with CM-500 plugged into front panel through AD1K
bill conkling
nr4c at widomaker.com
Tue Jan 21 19:50:02 EST 2014
The AD1K has a DC blocking cap built in. Plug it in the rear jack or use the battery box provided with the CM500 to provide bias.
...bill nr4c
Sent from my Verizon Wireless 4G LTE DROID
Stan Rowe <shrtuba at chartermi.net> wrote:
>Does anyone have any ideas why my Yamaha CM-500 microphone won't work when
>plugged into the front of the K3. I am using the Kenwood AD1K adapter and I
>have the firmware set to select the front panel, low gain, with bias on
>(FP.L bIAS). The CM-500 headphones are plugged into the Phones jack on the
>front of the K3 and work fine. The CM-500 mic plug (grey) is plugged into
>the corresponding jack on the AD1K. When I press my footswitch, the K3
>goes into transmit but there is no audio when I speak into the CM-500's
>microphone. I have tried the footswitch plugged in both on the back of the
>K3 and into the AD1K footswitch jack and it works fine (puts the K3 into
>transit) in both cases.
>
>
>
>When plugged into the rear Phone and Mic jacks on the K3, the CM-500 works
>like it should. In that case I have the firmware set to RP.L bIAS.and both
>the CM-500 microphone and headphones work fine, so I'm quite sure the CM-500
>is not the culprit.
>
>
>
>It almost seems like the AD1K is the problem.
>
>
>
>This must be something simple, but I am stuck. Any suggestions much
>appreciated.
>
>Thanks
>
>Stan - K6VWE
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>
More information about the Elecraft
mailing list