[Elecraft] Remote P3

[David Christ]

Dollars aside, there is real time hardware that would take output from the P3SVGA, compress it and stream it on the Internet.  You have some latency but the remote display might still be useable.

So that leaves the issue of control.  Follow along as I speculate.  In a normal installation the local computer goes to the P3 and then to the K3.  Would a remote installation still work if a P3 sat between the RemoteRig unit and the K3?  Elecraft describes how to connect a local computer running HRD to a Remote Rig setup.  Instead of HRD could you run the P3 utility to control the P3?

David K0LUM
On Jan 20, 2014, at 5:30 PM, Bruce Beford wrote:

> Unlikely. I don't know how practical it would be, even if you _did_ use a
> computer at the remote end. Some folks set up a webcam to view the P3
> display, I believe. This would be very bandwidth intensive, to get anything
> approaching a real-time rate and good resolution. "Controlling" the P3 would
> be another matter entirely.
> 
> Bruce N1RX
> 
>> Then the question morphs into the following:  If setting up a remote 
>> K-line without a computer at the remote end, is there any way to control a
>> P3 and view its output?
> 
>> David K0LUM
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html