[Elecraft] KPA Aux cable

[Jack Brindle]

The KPA only talks on the Auxbus, it does not listen. So yes, the four BAND signals are needed.

Jack Brindle, W6FB

Sent from my iPhone

> On Jan 20, 2014, at 5:23 PM, Phil Theis <phil at k3tuf.com> wrote:
> 
> In the KPA cable going to the K3 the band data lines are called out, yet there is no discussion about instructing the K3 firmware to set band data.   My band data is used for transverters with Config:KIO3 set to TRN.   If these lines are not used and band information is derived from AUXBUS, then do we really need the four band lines in the cable going from KPA to K3?
> thanks,
> Phil K3TUF
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html