[Elecraft] K3 - Remote activation of KAT500 via HRD

[WILLIS COOKE]

The best place to look is the HRD forum.  That is where the HRD experts gather.
 
Willis 'Cookie' Cooke, TDXS DX Chairman
K5EWJ & Trustee N5BPS, USS Cavalla, USS Stewart


________________________________
 From: Bill W <bw396ss at yahoo.com>
To: elecraft at mailman.qth.net 
Sent: Thursday, January 16, 2014 8:50 AM
Subject: [Elecraft] K3 - Remote activation of KAT500 via HRD
 

Hi All,
I have a question to ask this group as perhaps someone already has the
answer. The situation is as follows. I use HRD (Ham Radio Deluxe) to run my
K line (K3, P3, KPA500, KAT500) remotely once in a while. The “Tune” button
on the HRD's simulated "Radio Face" works fine in initiating the tune cycle
for the K3 internal ATU. However, when the internal ATU is bypassed, it will
not initiate the tune cycle for the KAT500. I am sure what is needed is a
code line change in the HRD code sequence for the "Tune” button but I have
no idea where to look for the appropriate sequence to use. I think I found
where to make the change in HRD.
Any insight would be appreciated.
73,
Bill – W0BBI




--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Remote-activation-of-KAT500-via-HRD-tp7582962.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html