[Elecraft] [QRO] KXPA100-AT ~ Can antenna 2 be disabled?

[mike]

Is it possible to disable antenna 2? The warning "Be sure you have an antenna
or dummy load connected to the active antenna port before transmitting" is a
bit animus for my occasional fumble fingers. I guess I could just remember
to hook up a 100w dummy load to antenna 2 when I set up, but it would be
nice to just remove the possibility via FW.

My KAT500 always remembers the last antenna used for the selected band. So I
guess that would be true with the AT in the KXPA100 and I could make sure to
set up each band I use with the correct antenna selection. The mistake I
don't want to make is holding the AT Tune / ANT button instead of taping it
and thereby selecting antenna 2. On the K3 they are two different buttons
and I am really unlikely to make the mistake.

I thought I read a post on this before, but could not find it in my
searches.  Tnx  ..mike  AI6II



--
View this message in context: http://elecraft.365791.n2.nabble.com/QRO-KXPA100-AT-Can-antenna-2-be-disabled-tp7582858.html
Sent from the Elecraft mailing list archive at Nabble.com.