[Elecraft] [KX3} Unable to engage screw into KXFL3

[Mark Petiford]

Re:  "I received my filter board for my KX3, but the ½”, 13mm screw will not
engage the screw hole in the filter board. "

Jamie,

As the instructions say, the "screw must pass into the hole in the KXFL3 module."  Mine just barely passes INTO the hole and does not project THROUGH the hole.  Its threads do not engage the surface of the hole at all since the hole diameter is larger than the screw diameter.  It works fine for keeping the module from falling out during transport.   
        
Hope that helps.

Mark
KE6BB