[Elecraft] P3 svga hangs

[Mike Flowers]

I have this happen occasionally, but only when I am transmitting with the
KPA500.   In RX and barefoot, it's solid.   I'm going to try some additional
snap-on ferrite chokes on the lines, etc. 

- 73 de Mike, K6MKF, W6NAG, Secretary - NCDXC, IDXG, RRC #933,
K3-P3-KPA500-KAT500 Addict, Maui


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of George Thornton
Sent: Friday, January 03, 2014 8:57 AM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] P3 svga hangs

I have the following setup:

K3 (with two receivers)

P3 with SVGA

Steppir 3 element Yagi 

External monitor attached to P3

I am having problems with the P3 SVGA being sluggish and periodically
locking up.  Sometimes the external monitor locks up, sometimes both.  I can
usually get it running by turning the P3 off and on.  This happens fairly
frequently and can be quite annoying.  The impression is the P3 SVGA is
overloaded and can't keep up.

The software is all up to date.  

Everything else seems to be working just fine.  

Any help would be appreciated.


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html