[Elecraft] KAT100 Power Calibration Problem

[Don Wilhelm]

Jeremy,

Tune the capacitor very slowly and use a non-metallic tool.  The null is 
sharp and deep.
You must have a good 50 ohm dummy load connected.
You may want to take your external wattmeter out of line to do the nulling.
The actual voltage will depend on the power level, at 5 watts it should 
be less than 10 mV, but you should be able to get it below 15 or 20 mV 
if the power is 10 watts.  If you are using 20 watts or more from the 
KPA100, then your 30 mV is probably OK.

Ideally, the voltage should go to zero, but being practical, one may not 
be able to adjust the capacitor in fine enough increments to achieve 
that goal.

73,
Don W3FPR

On 2/28/2014 4:32 PM, JeremyJones wrote:
> I just reread Dons post, and he says less than 10mV, so I guess I have some
> trouble shooting to do with that first,
>
> Jeremy
> VA3ZTF
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/KAT100-Power-Calibration-Problem-tp7584832p7584865.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>