[Elecraft] KAT500 Utility wakeup KAT500

[Dick Dievendorff]

The KAT500 Utility does need a little work to wake up a sleeping KAT500.

I'll try to get to it this week.

In the meantime, I'm using a command tester macro named "IDLE SLEEP OFF"
that sends ";;;SL0;SL;RV;"  I tap that macro key a few times until I see an
"SL0;" . This turns off idle sleep so you can load firmware and make
configuration changes that stick.  You can restore Idle sleep on with an
SL1; command or use the Edit Configuration dialog.

Alternatively, click "Test Communications" on the port tab and get back to
the firmware tab within 5 seconds and press "Send All Firmware".

73 de Dick, K6KR




-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Stan Gibbs, KR7C
Sent: Tuesday, February 25, 2014 15:59 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Need volunteers to try an even better version of
KAT500 firmware (rev. 1.63) -- more accurate initial tunes

Apparently, the KAT500 Utility (v1.14.2.20) doesn't send the requisite "wake
up" commands.

As far as the coarse tuning speed, I would say that it is much faster than
1.58.  I erased all memories and tried tuning antennas where the SWR is over
5 (e.g. 18 on my 80 dipole) and the KAT500 was really quick in finding a
good match.





-----
73, Stan - KR7C
--
View this message in context:
http://elecraft.365791.n2.nabble.com/Need-volunteers-to-try-an-even-better-v
ersion-of-KAT500-firmware-rev-1-63-more-accurate-initial-tunes-tp7584707p758
4725.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html