[Elecraft] New production FW releases

[Robert Bajuk]

Hi Richard,

I would say you have Trace checked under View in K3 Utility, I did it once
by mistake as well..

When "Trace" selected, shows detailed diagnostic trace information. Trace
may significantly increase the time required to complete operations such as
firmware load.

Check it out

73 Robert, S57AW





2014-02-23 21:19 GMT+01:00 Richard <hb9anm at bluewin.ch>:

> I loaded the latest FW releases 4.83 and 1.38 into my K3 and KPA500 (I
> don't own a KAT500) and everything works smoothly.
>
> But while the K3 (MCU, DSP1, DSP2) used to take some 7-8 minutes to load,
> it now takes over 30 minutes (yes, Utility 1.13.5.9 at 38400 bps) while all
> details appear on the screen, which was not the case earlier, although I
> had been using 1.13.5.9 previously.
>
>
> Anyone else noticed this?
>
>
> 73
> Richard - HB9ANM
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>