[Elecraft] K2 Won't power on

JeremyJones jjones9527 at gmail.com
Tue Feb 18 18:58:52 EST 2014


A new AA battery right from the package is giving me 1.615V on the fluke
meter.  This is a newer K2 (#7405).  I had some issues when building it
which caused me to go through a couple of sets of PA finals before I had to
send it to you to get sorted out.  It was working great until now, so
hopefully there isn't something residual that is creeping up now.  The
resistor values are all correct according to the manual.
R59 4.7k
R60 100
R61 120
R62 2.7k
R63 220

I am performing the voltage measurement on the Base pad of where Q8 would
go, and pressing and holding the "Tune" button on the front of the radio.

Jeremy


Don Wilhelm-4 wrote
> Jeremy,
> 
> Make a quick check on your voltmeter - measure a new Alkaline battery, 
> you should see quite close to 1.50 volts.
> 
> Are you making the measurement by using TUNE?  If not, you should be.
> 
> Is this an older K2 with a trimpot at R60?  If so, it should be turned 
> fully counterclockwise.
> Check the resistors R59 through R63 to be certain they are the correct 
> values.
> 
> I would be puzzled about a bias voltage higher than 0.64 volts because 
> it could lead to higher current and the resulting heat dissipation in 
> the PA transistors.
> 
> Thank you for adding a bit of the prior post that you are responding to 
> - it helps a lot.
> 
> 73,
> Don W3FPR
> 
> On 2/18/2014 4:46 PM, JeremyJones wrote:
>> I don't know how much over 0.64 volts is bad, but I am getting 0.656.
>>
>> I didn't realize that a web reply was cutting off what I was replying to. 
>> I
>> always hit the reply button and assumed it included the original text.
>>
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:

> Elecraft at .qth

> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html





--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-Won-t-power-on-tp7584083p7584416.html
Sent from the Elecraft mailing list archive at Nabble.com.


More information about the Elecraft mailing list