[Elecraft] CW QRQ and SPLIT

[Klaus Koppendorfer]

It is sad that QRQ mode has no RIT  !!!
Cw up from 30 to 35 WPM hast o use QRQ mode because of struggling dits and dahs

Many highspeed ops VHSC EHSC has changed from k3 to FT5000 because of leaking RIT with QRQ with K3

Maybe Wayne will sharpen Firmware in future for QRQ mode

If rit/split is necessary i use 2nd RX but this is not so comfortable

73
Oe6kyg
Klaus


-----Ursprüngliche Nachricht-----
Von: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] Im Auftrag von Don Wilhelm
Gesendet: Samstag, 15. Februar 2014 22:06
An: Jorge Diez - CX6VM; 'Elecraft Reflector'
Betreff: Re: [Elecraft] CW QRQ and SPLIT

Jorge,

AFAIK, probably not.  The frequency must be shifted from RX to TX, and with QRQ in effect it is not possible to shift that fast.  A K3 with 'chirp' on the ham bands would not be a nice thing to hear.

73,
Don W3FPR

On 2/15/2014 2:33 PM, Jorge Diez - CX6VM wrote:
> I saw in the manual of K3 that CW QRQ is "temporarily turned OFF" with 
> SPLIT.
>
> Will be in the future any way to use it in SPLIT mode or is impossible?
>
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html