[Elecraft] K3 10Mhz IF questions with the latest beta

[Eric NO3M]

Switch to the transverter band you setup using the BAND up/dwn buttons.  
When you see 334.076.00, move the VFO clockwise to pass the 0.000 point 
and continue upwards.... if you're headed for 475 kHz territory, set the 
VFO to Course tuning to get there faster.

DON'T enter direct frequency, doing that will change the freq. of the 
160M band slot, it just doesn't work the way you are expecting. That is 
why when you move down after entering the freq. you hit a wall at 490 
kHz.  For now, if you have a frequency in the transverter band to QSY 
to, move there with the VFO.

Running the 10 MHz IF here with dual diversity RX and TX.  Currently 
running a side-by-side digital mode TX test tonight around 475.5 kHz.

GL 73 Eric NO3M / WG2XJM

On 02/12/2014 11:09 PM, Jim AB3CV wrote:
> Also switching to 160 and back again reverts to 334.076.00 odd display.
>
> jim ab3cv (chasing V26M...)
>
>
>
>