[Elecraft] K2 Won't power on

[Don Wilhelm]

Jeremy,

Yes, you should be doing the resistance checks with no power applied.
Inexpensive ohmmeter?  Well, if it is a digital multimeter in resistance 
mode, you should be OK, but i it is an analog VOM or VTVM, it may not be 
showing you the real picture because the voltage may be sufficient to 
turn on semiconductor junctions.

73,
Don W3FPR

On 2/12/2014 9:15 PM, JeremyJones wrote:
> I have lifted R45, RFC4, R74, R82 and R97, with only a slight increase from
> 70 ohms to 87 ohms after lifting RFC4.  I'll continue troubleshooting
> tomorrow by removing any capacitors connected to 12V.
>
> I also want to confirm that I should be doing these resistance checks with
> no power applied.
> Also, I am using an inexpensive ohm meter.  Will that have enough power to
> charge the capacitors up enough to show the expected resistance?
>
> Thanks,
> Jeremy
> VA3ZTF
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/K2-Won-t-power-on-tp7584083p7584157.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>