[Elecraft] K2 bandwidth modification issue

Steve Garwood n0czv at frontier.com
Mon Feb 10 02:30:15 EST 2014


Hello!

I am working on a K2,  <3000 s/n in which I installed the K2 SSBCAPKT along with the 14 crystal kit.

Receive is working, audio level is low on the OP1 filter, normal on FL1, etc.
I have transmit, with good audio, however, no measurable power output or ALC reading.

I've been searching for something similar to this, no luck so far.....

It seems that the filter output is low, but functioning.....  Alignment addresses adjusting BFO frequency, but nothing about output level.

I checked soldering again, but I have not made it any further than this....

Any ideas?

Thanks

73,

Steve, N0CZV


More information about the Elecraft mailing list