[Elecraft] K3 and the LDG AT 600 Pro II

[Jim Bennett]

Hi Rob,

Up until a few months ago I had been using my K3, going into an Ameritron AL-811 amp, through the LDG AT-600 ProII, and then to an external 4:1 balun, 110 feet of 450 ohm ladder line, and an 88 foot long doublet. I also had the M-600 analog meter connected to the AT-600 ProII.

Nothing special was needed - I ran RG-8X coax from the K3 to the amp, from the amp to the '600, and from the '600 a couple of feet to the 4:1 balun.

The AT-600 was able to tune just about anything that the internal tuner in the K3 did, although not always as low of an SRW - but pretty darn close.

Jim / W6JHB

p.s. - I sold the tuner, meter, and amp to a local buddy and replaced them with the KAT500 and KPA500 for my birthday in November.



On   Wednesday, Feb 5, 2014, at  Wednesday, 11:27 AM, Robert Biamonte wrote:

> Hello,
> Has anyone connected the K3 to the LDG Auto Tuner 600 Pro II?  If so how did you do it(i know with a cable  :) )
> 73
> Rob WB2OMW
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html