[Elecraft] K3 utility help

[Sam Morgan]

you are quite correct,

just goes to show I am playing with to many different pieces of software 
that aren't as smart as elecraft's utils <g>

On 2/4/2014 3:25 PM, Mike Reublin wrote:
> I think the k3 Utility will match whatever the K3 is set to. AFAIR, it cycles thru all the baud rates.
>
> 73, Mike NF4L
>
> On Feb 4, 2014, at 4:19 PM, Sam Morgan <k5oai.sam at gmail.com> wrote:
>
>> check the utility baud rate is set correctly to match the k3's baud rate
>> CONFIG RS232
>>
>> On 2/4/2014 3:06 PM, Carl Yaffey wrote:
>>> I installed the utility and installed what I think is the driver via CDM c2.08.30 WHQL Certified.exe
>>> I connected the KUSB cable to the K3’s RS232 port. I started the utility and selected COM3 as it was the only choice.
>>> The utility cannot find the K3.
>>> What am I missing?
>>>
>>> Carl Yaffey  K8NU


-- 
GB & 73
K5OAI
Sam Morgan