[Elecraft] K3 utility help

[Mike Reublin]

I think the k3 Utility will match whatever the K3 is set to. AFAIR, it cycles thru all the baud rates.

73, Mike NF4L

On Feb 4, 2014, at 4:19 PM, Sam Morgan <k5oai.sam at gmail.com> wrote:

> check the utility baud rate is set correctly to match the k3's baud rate
> CONFIG RS232
> 
> On 2/4/2014 3:06 PM, Carl Yaffey wrote:
>> I installed the utility and installed what I think is the driver via CDM c2.08.30 WHQL Certified.exe
>> I connected the KUSB cable to the K3’s RS232 port. I started the utility and selected COM3 as it was the only choice.
>> The utility cannot find the K3.
>> What am I missing?
>> 
>> Carl Yaffey  K8NU
>> Banjo, guitar, bass, mandolin, dobro.
>> recording studio.
>> cyaffeyNO_SPAM at gmail.com
>> 614 268 6353, Columbus OH
>> http://www.carl-yaffey.com
>> http://www.grassahol.com
> 
> -- 
> GB & 73
> K5OAI
> Sam Morgan
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html