[Elecraft] [K2] R1 and D4 connecting?

[Vic Rosenthal K2VCO]

The schematic shows that D4 is connected to the wiper of R1. So yes, it 
is supposed to be like that!

On 2/1/2014 2:00 PM, Lane wrote:
> Since its a Saturday, thought I'd try here. I'm on the front panel board of
> the K2 and my eyes are playing games with me today.
>
> On pg. 24, a diode for D4 was installed.
> On pg. 26 a 5-k linear-taper R1 was installed.
>
> After installing these two and looking from the bottom side, it appears as
> if the center of the three leads from R1 and the left lead (band end) of
> the diode on D4 are so close together that they can touch? I didn't look
> too closely on these before adding R1 and tried to wick off any soldier,
> but my eyes are playing games on me today and I can't tell.
>
> I was hoping someone could confirm. Any help much appreciated.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

-- 
73,

Vic, K2VCO

Fresno CA

http://www.qsl.net/k2vco/