[Elecraft] K2DSP Default State

[Myron WVØH]

Thanks Don.

Myron WVØH
Printed on Recycled Data

> On Dec 30, 2014, at 5:36 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:
> 
> Myron,
> 
> You are not able to do that, but what you can do is set the KDSP2 FL1 position to LoPass for CW, SSB and RTTY (if applicable) - NR and NT off.
> That will cut the high frequency hiss and do nothing else.
> 
> If you find you need additional DSP filtering, then hold the AFIL button to change to FL2, FL3 and FL4 to give you additional degrees of DSP filtering.
> 
> I would suggest that you narrow the IF passband using XFIL as a first measure to eliminate QRM and noise before narrowing the AFIL setting.  The KDSP2 DSP is in the audio path only where the XFIL settings narrow the IF channel.
> 
> Note that the K3 is different, the DSP is processed at the 15 kHz IF frequency rather than at audio frequencies - so in the K3, the DSP determines the bandwidth of the IF channel.
> 
> 73,
> Don W3FPR
> 
>> On 12/30/2014 6:43 PM, Myron WVØH wrote:
>> How do I make the DSP bypassed by default when I power up my K2?
>