[Elecraft] P3 Bug

[Dauer, Edward]

No SVGA (and no computer link) here, yet the problem happens now and then
- often enough to be annoying - just as others have described it.  I am
almost sure I am using QSK ³old.²  The K3 is about 100 miles from where I
am right now so I can¹t confirm that.

While I am not 100% sure of this, it may be that the recovery delay has
happened only when working split with the sub RX enabled.  On the other
hand, that would be the only time I would care about it since it would be
the only circumstance in which I would be trying to use the P3 to position
my transmissions, so my perception may be skewed.

Ted, KN1CBR

 
>
>
>------------------------------
>
>Message: 17
>Date: Mon, 29 Dec 2014 17:58:58 -0500
>From: Don Wilhelm <w3fpr at embarqmail.com>
>To: elecraft at mailman.qth.net
>Subject: Re: [Elecraft] P3 bug
>Message-ID: <54A1DCB2.9030503 at embarqmail.com>
>Content-Type: text/plain; charset=windows-1252; format=flowed
>
>In addition, there is now QSK OLD and QSK NEW which now adds another
>variable into the K3 'return to RX after TX equation'.
>
>If all parties responding with additional information would state which
>they are using, perhaps it will be easier to get to the root cause of
>this behavior.
>
>I have no idea if this is a factor in the "it does it" or "it does not
>do it here" statements, but information related to the relevant K3 setup
>and applications running on the computer certainly seem to be a part of
>it (even though some have seen it without computer applications).
>
>I don't think I have seen any reports of the problem being encountered
>with non-SVGA P3s.
>
>73,
>Don W3FPR
>