[Elecraft] P3 bug

[Mike K2MK]

Hi Don,

I've had this problem for several years and I only started using QSK this
year. Further, the problem is also present when using RTTY (AFSK). I don't
use SSB very often so I have not noticed if the problem is present with that
mode.

All firmware for the K3, P3, and SVGA are the latest, either production or
beta.

I run WriteLog for both CW and RTTY. But for the testing I just posted about
I had no PC applications running and the K3 in test mode.

My K3 settings are generally all default values. If there is something
specific needed I can look it up and advise.

I checked the refresh rate on the P3 and it was set at 10ms which is per the
manual. I raised it to 20ms and the problem persists. I raised it 100ms and
the problem persists.

73,
Mike K2MK


Don Wilhelm-4 wrote
> In addition, there is now QSK OLD and QSK NEW which now adds another 
> variable into the K3 'return to RX after TX equation'.
> 
> If all parties responding with additional information would state which 
> they are using, perhaps it will be easier to get to the root cause of 
> this behavior.
> 
> I have no idea if this is a factor in the "it does it" or "it does not 
> do it here" statements, but information related to the relevant K3 setup 
> and applications running on the computer certainly seem to be a part of 
> it (even though some have seen it without computer applications).
> 
> I don't think I have seen any reports of the problem being encountered 
> with non-SVGA P3s.
> 
> 73,
> Don W3FPR





--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-bug-tp7596500p7596527.html
Sent from the Elecraft mailing list archive at Nabble.com.