[Elecraft] [PX3] v1.16 Bug?: Cursor in AM mode

[Alan]

The KX3 (and K3) bandwidth controls are with respect too the audio 
frequency, not the RF frequency.  So in LSB mode, for example, the 
bandwidths move in opposite directions on the KX3 and PX3.  In AM mode, 
the bandwidth is mirrored about the carrier frequency.

Alan N1AL


On 12/23/2014 02:01 AM, JE0LFI wrote:
> Hi
>
> In AM mode,
>
> When I specified the PBT to Low=0.0 and Hi=4.0, the cursor's low side(PBT I)
> displayed in the left side of the center. And hi side(PBT II) displayed in
> the right side of the center.
>
> The band width of the cursor, looks like more than 4.0KHz across the center
> frequency.
>
> Is this correct?
>
> 73,
>
> JE0LFI / Nakamura
>
> #wish FixTrack mode and SYNC-AM mode
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/PX3-v1-16-Bug-Cursor-in-AM-mode-tp7596296.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>
>