[Elecraft] K3 13.8 VDC power

[Richard Fjeld]

Thanks Roger, that information is rewarding.

Imagine what would happen if a power outage occurs during a firmware 
upload. The odds are slim, but my middle name is 'Murphy'.
I want a good battery in my laptop as well.  It has to finish the upload.

Dick, n0ce


On 12/23/2014 10:09 AM, Roger D Johnson wrote:
> It IS possible to send the K3 off to never-never land by removing the 
> 12 volt input before
> shutting the radio off with the power switch. I've had it happen 
> whilst mucking around
> behind my desk and accidentally pulling out the Anderson power-pole 
> connector.
>
> If you've saved the settings using the K3 utility, you can reset 
> everything using the
> procedure on page 63 of the K3 manual. NOTE: This did not work with my 
> rotor
> control plugged into the ACC socket! If you didn't save the 
> parameters, you will
> have to manually reset everything! SAVE!
>
> 73, Roger
>
>