[Elecraft] KPA500-KAT500-K3 problem

[Sam Morgan]

Yes RADIO is still set for K3.

Last night I had never even touched the cable that went between the 
KPA500 and the KAT500. Unless Murphy got in here while I was sleeping 
and broke a wire inside the cable that hadn't been touched...

yea I know stranger things than that have happened b4, hi hi.

On 12/22/2014 10:01 AM, Jack Brindle wrote:
> The KPA is still set for RADIO= K3, right? Shortly after power up,
> the KPA will send its on state to the K3 using the Auxbus, but only
> if it is told the radio is a K3. The symptom is that this is not
> being received by the K3. The logical conclusion is that something is
> blocking it. Nothing messed up on pin 2 of the AUX cable, right?
>
> I don't remember if the K3 must be told about the KPA (don't think
> so, but that would have been long ago...), but if so make sure of
> that setting.
>
> I'll research this a bit more when I get back to my info system,
> maybe an hour...
>
> 73, JackB, W6FB

-- 
GB & 73
K5OAI
Sam Morgan