[Elecraft] KPA500-KAT500-K3 problem

[Sam Morgan]

The only cables changed during my clean up were:
I removed the VGA cable from the P3 (the one that went to the external 
monitor)

I then took that end that had gone into the rear of the P3, and inserted 
it into a 4 way switchbox.

I then added a new VGA cable from the switchbox to the rear of the P3

==
at no time were any other cables unseated, removed, replaced, or 
otherwise messed with. (other than being lifted so the vga cable could 
be untangled from them if needed during the change over of the VGA P3 
cable)

On 12/22/2014 9:35 AM, Dick Dievendorff wrote:
> I'd try swapping the 15-pin cables between K3 and KAT500 and KAT500 to
> KPA500 if there's any possibility you swapped them in your cleanup effort.
>
> If you could possibly  have swapped in an SVGA cable, I'd do some ohmmeter
> checking to see that all the cable pins are connected straight thru and not
> connected to one another.
>
> 73 de Dick, K6KR
>


-- 
GB & 73
K5OAI
Sam Morgan