[Elecraft] W6JHB K3/KAT500 Synchronization

James Bennett w6jhb at me.com
Thu Dec 18 13:37:30 EST 2014


Ah-ha!!! Many thanks guys - that did it. Perhaps I need to update my manual set for the K-line.

Appreciated - working as designed.

73, Jim


> On   Thursday, Dec 18, 2014, at  Thursday, 10:31 AM, Howard K6IA Elecraft Support <k3support at elecraft.com> wrote:
> 
> Hi Jim,
> 
> Please review this link info and I think it will be helpful in getting KAT500 VFO tacking to working for you.
> 
> <http://www.elecraft.com/manual/K3-KAT500%20setup%20with%20new%20firmware%20releases.pdf> <http://www.elecraft.com/manual/K3-KAT500%20setup%20with%20new%20firmware%20releases.pdf>
> 
> Regards,
> 
> Howard K6IA
> ----------
> 73, Howard Stephenson  K6IA
> Elecraft Customer Support
> (831) 763-4211 EXT 169
> 
> 
>> 
>> 
>> -------- Forwarded Message --------
>> Subject:	[Elecraft] K3/KAT500 Synchronization
>> Date:	Thu, 18 Dec 2014 10:17:21 -0800
>> From:	James Bennett <w6jhb at me.com> <mailto:w6jhb at me.com>
>> To:	Elecraft Reflector Reflector <elecraft at mailman.qth.net> <mailto:elecraft at mailman.qth.net>
>> 
>> Forgive me if this has been discussed (and answered) before but I do not find it in the archives. A while back there was a firmware update that would allow the KAT500 to “automatically” select the memorized L/C values as the K3 was tuned across a band. I have the current firmware in both units, but do not see (hear) the KAT500 doing anything as I tune across the band. For example, I just set the K3 at 14.006 and tapped the key paddle. The tuner clicked once and lit up the LED at the 1.2 mark. I then turned the K3’s VFO knob up to 14.080 - not a sound to be heard while tuning. When I got to that frequency, I tapped the key again and heard a short relay click noise and again got the 1.2 LED.
>> 
>> So, my K3 and KAT500 are not doing what I thought the changed firmware was supposed to do. Is this something I need to set in a menu parameter in one or both units? Or, is this still a change residing in a beta version of the firmware?
>> 
>> Thanks, Jim / W6JHB
>> ______________________________________________________________
>> 
>> 
> 



More information about the Elecraft mailing list