[Elecraft] 3D Printed KX3 stand

[George via Elecraft]

I just made mine in the ole woodshop to carry the KX3 and PX3 together. Its about an inch and a half higher off the desk and fairly upright 
to make it feel like a single radio. Its oak so it pretty heavy and I put some grip pad on the bottom to keep it from moving around the desk with key presses 
and vigorous tuning. My next job is to make a wood cradle to hold the 100 watt amp behind it. 

George NE2I



On Dec 14, 2014, at 8:13 PM, Michael Walker <va3mw at portcredit.net> wrote:

> If I do, I will post it on Thingiverse.
> 
> Mike va3mw
> 
> 
> On Sun, Dec 14, 2014 at 8:58 PM, Bob N3MNT <bob at hogbytes.com> wrote:
>> 
>> Looks like you will be designing one. Hope you will share.
>> 
>> 
>> 
>> 
>> --
>> View this message in context:
>> http://elecraft.365791.n2.nabble.com/3D-Printed-KX3-stand-tp7595977p7595979.html
>> Sent from the Elecraft mailing list archive at Nabble.com.
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to va3mw at portcredit.net
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ne2i at yahoo.com