[Elecraft] Quirk in KX3 memory recall

[Peter Lambert]

I recently fitted the 2m module and have just programmed the KX3 with the
local 2m repeater frequencies.

The module works brilliantly and a good 4W out.  Audio quality is very good
both RX and TX.  Nice addition that finishes off everything I'd want in the
KX3.

Noticed one really minor thing for the todo list.

If you press RCL and then rotate VFO knob to select a memory, then "press
any key to exit", the TX/RX frequencies and tones etc are loaded normally.

However if you press RCL the previously selected memory is displayed, if you
then press any key the TX/RX frequencies are not loaded.  You have to rotate
the VFO A knob to select a memory that is different than the one you
selected previously.

Very minor in that in normal use you'd probably never notice this.  I'm
fiddling and just went to recall the same memory that I'd recalled
previously.

Cheers,
Peter VK4JD