[Elecraft] Fw: KX3 2 mtr ATU problem

[ejkkjh at gmail.com]

This is my second post on this problem, got no replies on first one, still looking for help for transmitting below 5 Mhz and getting very high SWR.
I also connected a dummy load directly to the KX3, same problem.
Using the tune button and by-passing the ATU get SWR readings of 99.9 with dummy load on freqs below 5 Mhz?
So it probably is not the ATU.
When installing the 2 meter module I had to move the inductors, the 2 mtr antenna connector was touching one inductor, fit was very tight.  
I have rechecked 2 meter module install nothing obvious.
Thanks for help.  73
Emory  WM3M

From: ejkkjh at gmail.com 
Sent: Saturday, August 16, 2014 7:41 PM
To: elecraft at mailman.qth.net 
Subject: KX3 2 mtr ATU problem

I installed the KX3 2 meter module about a week ago, it all seemed to go ok.
The module seems to work fine but now the ATU in the KX3 will not tune up on 80 or 160.
Best SWR KX3 shows is  about 10-1 on freqs I have used many times before where ATU used to get near 1.1. 
I used same cables, antenna, with different tuner and HF rig, two different antennas, tune up fine as before.
Any help or ideas would be appreciated.  73  and Thanks
Emory  WM3M