[Elecraft] KX3 and FLDIGI

[Bill Frantz]

Consider disconnecting the RS-232 connection and leaving the 
audio connection. Then use VOX to key the transmitter. If that 
leaves the mode unchanged, then something from HamLib is 
changing the settings on the KX3.

Cheers - Bill, AE6JV

On 4/22/14 at 6:28 PM, don at w3fpr.com (Don Wilhelm) wrote:

>You might want to try using RigCAT instead of HamLib  - choose K3 if KX3 is not available.
>The only function necessary is PTT keying and the proper display of frequency on the waterfall.
>
>73,
>Don W3FPR
>
>On 4/22/2014 8:50 PM, Adrien Dessemond wrote:
>>Don,
>>
>>My error I apologize, "AUDIO A" should be read as "DATA A" in my
>>original post. My concern was the transmission mode used by the KX3
>>once FLDIG triggered a data transmission as it does not seem to stay
>>in "DATA A" mode anymore, I will dig inside the Hamlib ...  :-) Thank
>>you your answers.
---------------------------------------------------------------------------
Bill Frantz        |"After all, if the conventional wisdom was 
working, the
408-356-8506       | rate of systems being compromised would be 
going down,
www.pwpconsult.com | wouldn't it?" -- Marcus Ranum