[Elecraft] K3 Error message ERR I01

[Sam Morgan]

wikipedia says MISO is a bus logic signal

MISO : Master Input, Slave Output (output from slave).

https://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus

now what that means to your situation someone else will have to tell 
you, I'm clueless. Is this happening when you are trying a firmware 
update, at powering on the K3 or during what action are you taking when 
this appears?

On 4/17/2014 10:18 PM, Robert Mccormack wrote:
> Early model (#321) displays ERR I01, indicating MISO line stuck low (asserted).
>
> I can't find any reference to 'MISO line' in the manual.   Any help would be much appreciated.
>
> 73,
> Ken ZL1AIH

-- 
GB & 73
K5OAI
Sam Morgan