[Elecraft] K3: reduced PWR in Data Mode on 10m only

[Bob KD7YZ]

If I use CW then I get whatever the rig will put out, on 10m. The VSWR
shows about 1.3:1

When I switch to Digital then I get about 6w out from 0 to 11w, as
indicated when I turn the "PWR" knob.

When I turn the PWR knob higher then though it indicates from 11 to 100,
the output, as seen on the Elecraft W2, is circa 0 to 1 watt.

Until I go to CW, as I said, then the output is correct, the K3 dial
shows the correct number of bars and so forth.

All other bands work fine on Tx-Data mode.

The antenna is not the problem. I figure there is a setting somewhere I
have messed up. However, this must be an elusive setting.


-- 

Bob KD7YZ
AMSAT LM 0901
http://www.qrz.com/db/KD7YZ
www.denstarfarm.us/LGD