[Elecraft] [K2] VFO alignment & display accuracy

[Sean Michael Johnston]

I have been trying to get my VFO aligned by adjusting C22 based on the methods recommended by N6KR and as posted in the app notes on the Elecraft website - http://www.elecraft.com/Apps/notes_on_adjusting_c22.htm.
I can never get it closer than 70 Hz. I am using the 10MHz WWV signal for reference. When I switch between TP1 and TP2 the closest match I can reach is between 4913.05 and14912.97. I tried to adjust for a -70 Hz offset while connected to TP2, but 14912.97 is as far as the I can go before the count starts to rise again.
I saw an older post where Don W3FPR mentioned changing C21 to a different value. Would this solve my issue, and if so, are there any suggestions as to which value I should use?

Thanks - Sean K5SMJ (formerly KG5AJZ)