[Elecraft] [P3] fatal error

[Alan Bloom]

Try doing the Parameter Initialization (see Troubleshooting section of 
P3 Owner's Manual.)  Basically you hold the LABELS key while turning on 
the power with the POWER key.

Alan N1AL


On 04/10/2014 07:27 AM, George Dubovsky wrote:
> OK, I just spent 2 hours as W1AW/4 on 40 cw and everything was working
> fine. I changed bands and the P3 displayed:
>
> ****FATAL ERROR****
> In: ddc_set_coef()
> span=0
>
> Press any active key to escape
>
> But all keys are dead, so no escape from the black screen of death. Power
> down/up does no change the message. Does anyone know what I'm up against
> here? Oh, this P3 has the SVGA board installed which I am not using.
>
> 73,
>
> geo - n4ua
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>
>