[Elecraft] K3 Utility and 1mW Calibration

[Dick Dievendorff]

The utility disables the dialog pages when it cannot communicate with the
K3.  Try the port tab, test communications.

Also the milliwatt calibration dialog items are disabled if your KXV3 has
not been enabled in the K3 CONFIG:KXV3 menu.

73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jim Rogers
Sent: Wednesday, April 09, 2014 15:50 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Utility and 1mW Calibration

K3 says I got the 2M module installed etc., status LED flashes normal, but
when I try to run the K3 Utility 1mW calibration it is all greyed out. I
have missed something somewhere....

Jim, W4ATK

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to dick at elecraft.com