[Elecraft] K3 TX TEST Mode via Software

[Mike Reublin]

Brian -

The IC command will return the status of the "TEST" setting. In the first byte, bit 5 will be 0 if normal, A if in test. See page 13 of the K3 & KX3 Programmers Reference.

73, Mike NF4L

On Apr 9, 2014, at 8:43 AM, Brian Alsop <alsopb at nc.rr.com> wrote:

> I'm using the K3 for measurements and want it to be in the TX TEST mode.
> 
> The software uses SWH18.  However, it is a toggle.  So if "*hit" happens and you have to run the data collection software again, it returns the K3 to the normal mode.
> 
> I've scanned the manual looking for a command which does the same but is not a toggle.  NADA.
> 
> Any workarounds?
> 
> 73 de Brian/K3KO
> 
> 
> 
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2012.0.2247 / Virus Database: 3722/6813 - Release Date: 04/07/14
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nf4l at nf4l.com