[Elecraft] KRC2 and TS480

[Robert Bajuk]

Hi Steve,

I have KRC2 which works without issue with my remote TS-480.

I had conversation with Gary from Elecraft some time ago and his setup
proposal works OK for me.

Jumper settings inside KRC2:
-------------------------------------------
Jumpers IN: 3, 6, 9, 10, and 21-23
Jumpers 14 & 17 bridged with voltage from pin 7 of U2 fed to this jumper
(~2" piece of wire).

Jumpers W7 and W8 depend of data rate, see KRC2 manual page 20

Hope it helps

73 Robert, S57AW




2014-04-08 12:52 GMT+02:00 Steve Bunting <stephen.bunting at virgin.net>:

> Hi everyone,
>
>
> I have KRC2 band decoder that I used ages ago with my K2 - it still works
> in that I can toggle bands when I hold the F1 button. I want to use it with
> my remote TS-480 but the radio CAT isn't currently driving KRC2 at all and
> I would like some advice on how to get it working, please.
>
>
> Current set up: I have used the Kenwood jumper positions from the KRC2
> manual and have a straight through serial cable from rig to KRC2. I am
> using 4800 baud (W7 and W8 in place) and the radio CAT works with my PC.
> The KRC2 is certainly in operate mode and I have a 13.8V PSU attached
> (stating the obvious!)
>
>
> Questions: I suspect I need to apply the handshake jumper between W14 and
> W17 for the TS-480? Does the position of W7 and W8 matter for 4800 baud?
> I'm assuming the manual is correct. Can any 480/KRC2 users comment on
> anything else I have missed?
>
>
>
> 73
>
> Steve
>
> M0BPQ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rbajuk at gmail.com
>