[Elecraft] K3 Wattmeter Cal and Tech Mode

[Ken K3IU]

If memory serves me, you need to have the K3 in the "range" 
before the CONFIG:WMTR will indicate that range, e.g., if 
you have it set for 5 watts, it will show LP; if you have 
set >12 watts, it will say HP.
73, Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
On 4/7/2014 9:30 AM, Ed G wrote:
> Folks,
>       While attempting to do a K3 wattmeter calibration, I go into the CONFIG
> menu.  However, I only see "WMTR MW" and I cannot select any other power
> settings, such as LP or HP.  I ten checked to make sure the TECH MODE is on.
> Going to that entry, I see "Funct ion" which I assume is On.  However, I
> cannot get this entry to turn off; when I rotate the main knob the setting
> does not alternate between on and off...it always stays on.
>
> 1.  How do I get into the wattmeter settings if tech mode is already on?
> 2.  and how do I turn tech mode off after I am done with wattmeter
> calibration?
>
> Thanks for any hints.
>
> --Ed--
>   
>
>
> ---
> This email is free from viruses and malware because avast! Antivirus protection is active.
> http://www.avast.com
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to kenk3iu at cox.net
>