[Elecraft] K3 Wattmeter Cal and Tech Mode

[Ed G]

Folks,
     While attempting to do a K3 wattmeter calibration, I go into the CONFIG
menu.  However, I only see "WMTR MW" and I cannot select any other power
settings, such as LP or HP.  I ten checked to make sure the TECH MODE is on.
Going to that entry, I see "Funct ion" which I assume is On.  However, I
cannot get this entry to turn off; when I rotate the main knob the setting
does not alternate between on and off...it always stays on. 

1.  How do I get into the wattmeter settings if tech mode is already on?
2.  and how do I turn tech mode off after I am done with wattmeter
calibration?

Thanks for any hints.

--Ed--
 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com